Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.2. Hinged components of a body
8.3. Body glazing
8.4. Seats
8.5. Conditioner and heater
8.5.1. Coolant
8.5.2. Air filter
8.5.3. Block of the air conditioning system
8.5.4. Evaporator
8.5.5. Broad valve
8.5.6. Condenser
8.5.7. Check of a radiator of a heater
8.5.8. Removal and installation of a back air duct
8.5.9. Removal and installation of the compressor of the air conditioning system
8.5.10. Dismantling and assembly of the obgonny coupling
8.5.11. Adjustment of the obgonny coupling
8.5.12. Check of the obgonny coupling
8.5.13. Removal and installation of the condenser
8.5.14. Check of the condenser
8.5.15. Removal and installation of lines of coolant (LF)
8.6. Tables
 








8-5-11-regulirovka-obgonnojj-mufty.html

8.5.11. Adjustment of the obgonny coupling

Измерение зазора по окружности между нажимным диском и шкивом компрессора
Fig. 8.73. Measurement of a gap on a circle between a press disk and a pulley of the compressor


Measure a gap on a circle between a press disk and a pulley of the compressor of the air conditioning system, using the feeler gage (fig. 8.73).
Make sure that the gap meets standard.

Установка новой прокладки между нажимным диском и шкивом компрессора
Fig. 8.74. Installation of new laying between a press disk and a pulley of the compressor


If it not so, remove press a disk and adjust a gap selection of laying of 0,2-0,5 mm or several laying (fig. 8.74).

"previous page
8.5.10.1. Removal of a bolt of the obgonny coupling
following page"
8.5.12. Check of the obgonny coupling