Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.2. Hinged components of a body
8.2.1. Removal and installation of a cowl
8.2.2. Adjustment of provision of a cowl
8.2.3. Removal and installation of the panel of a forward wing
8.2.4. Removal and installation of a front bumper
8.2.5. Removal and installation of a rear bumper
8.2.6. Doors
8.2.7. Removal and installation of a forward door
8.2.8. Removal and installation of a back door
8.2.9. Adjustment of a door
8.2.10. Adjustment of a door of a back
8.2.11. Removal and installation of glass of a forward door
8.2.12. Removal and installation of glass of a back door
8.2.13. Removal and installation of the block of a forward door
8.2.14. Removal and installation of the block of a back door
8.2.15. Window regulators
8.3. Body glazing
8.4. Seats
8.5. Conditioner and heater
8.6. Tables
 








8-2-9-regulirovka-dveri.html

8.2.9. Adjustment of a door

Схема регулировки дверей
Fig. 8.22. Scheme of adjustment of doors


Measure a gap and a difference of heights between a forward or back door and a body (fig. 8.22).
Weaken bolts of fastening of a door loop or screws of fastening of a clamp of the lock of a door, and adjust a door.
Standard gap:
and – 2,7–4,7 mm;
b – (top) of 1,0-1,0 mm;
b – (middle) of 0,5-1,5 mm;
b – (bottom) of 0,3-1,3 mm;
c – (top) of 1,0-1,0 mm;
c – (bottom) of 0,5-1,5 mm;
d – (top) of 1,0-1,0 mm;
d – (bottom) of 0,5-1,5 mm.
Tighten bolts or screws.

"previous page
8.2.8. Removal and installation of a back door
following page"
8.2.10. Adjustment of a door of a back