Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.2. Hinged components of a body
8.2.1. Removal and installation of a cowl
8.2.2. Adjustment of provision of a cowl
8.2.3. Removal and installation of the panel of a forward wing
8.2.4. Removal and installation of a front bumper
8.2.5. Removal and installation of a rear bumper
8.2.6. Doors
8.2.7. Removal and installation of a forward door
8.2.8. Removal and installation of a back door
8.2.9. Adjustment of a door
8.2.10. Adjustment of a door of a back
8.2.11. Removal and installation of glass of a forward door
8.2.12. Removal and installation of glass of a back door
8.2.13. Removal and installation of the block of a forward door
8.2.14. Removal and installation of the block of a back door
8.2.15. Window regulators
8.3. Body glazing
8.4. Seats
8.5. Conditioner and heater
8.6. Tables
 








8-2-5-snyatie-i-ustanovka-zadnego-bampera.html

8.2.5. Removal and installation of a rear bumper

Disconnect a negative wire from the rechargeable battery.
Remove an overlay of a luggage carrier.
Remove fastenings and unbend a side overlay of a luggage carrier a little. (right)
Remove fastenings and unbend a side overlay of a luggage carrier a little. (left) (4SD)
Uncover a technological opening. (left) (5HB)
Remove the back combined lamp.
Disconnect the socket of a lamp of illumination of registration plate.

Снятие заднего бампера
Fig. 8.15. Removal of a rear bumper: 1 – screw A; 2 – screw B; 3 – screw C; 4 – A connector; 5 – A bolt; 6 – B connector; 7 – rear bumper; 8 – reflector; 9 – B bolt; 10 – amplifier of a rear bumper


Remove in the order shown in the figure 8.15.
Remove a rear bumper.
Allocate regions of a rear bumper (a wheel niche) outside.
Attach a rear bumper to a body.
Press on connecting parts of a rear bumper towards a body to insert them into bumper locks.
Establish as it should be, the return to removal.

"previous page
8.2.4. Removal and installation of a front bumper
following page"
8.2.6. Doors