Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.2. Hinged components of a body
8.2.1. Removal and installation of a cowl
8.2.2. Adjustment of provision of a cowl
8.2.3. Removal and installation of the panel of a forward wing
8.2.4. Removal and installation of a front bumper
8.2.5. Removal and installation of a rear bumper
8.2.6. Doors
8.2.7. Removal and installation of a forward door
8.2.8. Removal and installation of a back door
8.2.9. Adjustment of a door
8.2.10. Adjustment of a door of a back
8.2.11. Removal and installation of glass of a forward door
8.2.12. Removal and installation of glass of a back door
8.2.13. Removal and installation of the block of a forward door
8.2.14. Removal and installation of the block of a back door
8.2.15. Window regulators
8.3. Body glazing
8.4. Seats
8.5. Conditioner and heater
8.6. Tables
 








8-2-14-snyatie-i-ustanovka-bloka-zadnejj-dveri.html

8.2.14. Removal and installation of the block of a back door

Remove glass of a back door.
Remove the internal handle.
Remove the loudspeaker of a back door.
Disconnect the window regulator electric motor socket with the servo-driver and the automatic socket of the executive mechanism of the lock of a door.
Remove a plait of a back door from the block of a back door.
Turn off bolts.
Remove a hook of the executive mechanism of the lock of a door from its block.

Снятие блока передней двери
Fig. 8.30. Removal of the block of a forward door


Pull the block of a back door a little to yourself, without allowing the window regulator regulator to be latched with the servo-driver on it, take out the block from a door (fig. 8.30).
Take out an internal cable of the handle and a cable of the button of the lock of a door from an opening.

Снятие ручки регулятора и стклоподъемника
Fig. 8.31. Removal of the handle of the regulator and stklopodjemnik


If your car is equipped with system of window regulators with the servo-driver, remove the electric motor and the regulator of a window regulator with the servo-driver from the door block. If the car is not equipped with system of window regulators with the servo-driver, remove the handle of the regulator and a window regulator (fig. 8.31).
Establish as it should be, the return to removal.

"previous page
8.2.13. Removal and installation of the block of a forward door
following page"
8.2.15. Window regulators