Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.2. Hinged components of a body
8.2.1. Removal and installation of a cowl
8.2.2. Adjustment of provision of a cowl
8.2.3. Removal and installation of the panel of a forward wing
8.2.4. Removal and installation of a front bumper
8.2.5. Removal and installation of a rear bumper
8.2.6. Doors
8.2.7. Removal and installation of a forward door
8.2.8. Removal and installation of a back door
8.2.9. Adjustment of a door
8.2.10. Adjustment of a door of a back
8.2.11. Removal and installation of glass of a forward door
8.2.12. Removal and installation of glass of a back door
8.2.13. Removal and installation of the block of a forward door
8.2.14. Removal and installation of the block of a back door
8.2.15. Window regulators
8.3. Body glazing
8.4. Seats
8.5. Conditioner and heater
8.6. Tables
 








8-2-10-regulirovka-dveri-zadka.html

8.2.10. Adjustment of a door of a back

Схема регулировки двери задка
Fig. 8.23. Scheme of adjustment of a door of a back


You will measure a gap and a difference of heights between a door of a back and a body (fig. 8.23).
Weaken nuts of fastening of the hinge of a door of a back and adjust a back door.
In case of need, weaken bolts of fastening of a clamp of the lock of a door of a back and adjust a back door.
Standard gap:
a – 5,0–7,0 mm;
b – 2,0–0 mm;
c – 3,5–6,5 mm;
d – 1,7–0,7 mm;
e – 4,0–8,0 mm.
Tighten nuts or bolts.

"previous page
8.2.9. Adjustment of a door
following page"
8.2.11. Removal and installation of glass of a forward door