Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
7.1. General information
7.2. System of power supply
7.3. System of lighting
7.4. Screen wipers and windscreen washers
7.5. Immobilizer
7.6. Checks of electric equipment
7.6.1. Mode of check of input-output of a combination of devices
7.6.2. Check of the loudspeaker of a forward door
7.6.3. Check of the forward loudspeaker of the top sound frequencies
7.6.4. Check of an antenna feeder
7.6.5. Check of the switch of control of the audio system
7.6.6. Check of the electric motor of a window regulator with the servo-driver
7.6.7. Check of the main switch of a window regulator with the servo-driver
7.6.8. Check of the switch of a window regulator with the servo-driver
7.6.9. Check of thread of heating of back glass
7.6.10. Check of external mirrors with the electric drive
7.6.11. Check of the switch of external mirrors with the electric drive
7.6.12. Check of the lock and executive mechanism of the lock of a back door
7.6.13. Check of the lock and executive mechanism of the lock of a forward door
7.6.14. Check of operating lighting switch on the dashboard
7.7. Tables
8. Body
 








7-6-8-proverka-vyklyuchatelya-steklopodemnika-s-servoprivodom.html

7.6.8. Check of the switch of a window regulator with the servo-driver

Measure tension on conclusions (except conclusions of G and H).
If tension differs from specified in the table, check the elements and the corresponding plaits of wires specified in the column "Checked Elements".
Disconnect a negative wire from the rechargeable battery.
Check the window regulator switch socket with the servo-driver for integrity of a chain between conclusions of G and H.
If the system does not work properly even on condition of serviceability of elements or corresponding plaits of wires, replace the switch of window regulators with the servo-driver.

"previous page
7.6.7. Check of the main switch of a window regulator with the servo-driver
following page"
7.6.9. Check of thread of heating of back glass