Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
6.1. General information
6.2. Brake system
6.2.1. Check and adjustment of elements of the brake system
6.2.2. Check of level of brake fluid in a tank of a hydraulic actuator of the working brake system
6.2.3. Removal of air from the brake system
6.2.4. Check of the backpressure valve of a vacuum hose (amplifier of brakes)
6.2.5. Removal and installation of a vacuum hose (amplifier of brakes)
6.2.5.1. Check of a pedal of a brake
6.2.6. Removal and installation of a pedal of a brake
6.2.7. Removal and installation of the main brake cylinder
6.2.8. Check of the sensor of level of liquid
6.2.9. Removal and installation of the vacuum amplifier of brakes
6.2.10. Check of the vacuum amplifier of brakes
6.2.11. Dismantling and assembly of the main cylinder
6.2.12. Removal and installation of a forward brake disk
6.2.13. Replacement of front brake shoes
6.2.14. Removal and installation of the back disk brake mechanism
6.2.15. Check of the parking brake system
6.2.16. Removal, check and installation of the back sensor of speed of a wheel of ABS
6.2.17. Removal and installation of the hydraulic block of anti-blocking system of brakes
6.3. Tables
7. Onboard electric equipment
8. Body
 








6-2-5-snyatie-i-ustanovka-vakuumnogo-shlanga-usilitel-tormozov.html

6.2.5. Removal and installation of a vacuum hose (amplifier of brakes)

Отсоединение разъема вакуумного шланга
Fig. 6.11. Detachment of the socket of a vacuum hose


Disconnect the socket of a vacuum hose from the amplifier of brakes, pressing uvulas of the socket of a vacuum hose (fig. 6.11).

Снятие хомута
Fig. 6.12. Removal of a collar


Remove a collar, using flat-nose pliers, and disconnect a vacuum hose from an inlet collector (Z6) (fig. 6.12).

Отсоединение вакуумного шланга от впускного коллектора
Fig. 6.13. A detachment of a vacuum hose from an inlet collector


Insert the thin screw-driver with flat shliyets in the point designated by an arrow in the figure 6.13, displace a ring down and disconnect a vacuum hose from an inlet collector (LF).
Remove a vacuum hose.
Establish as it should be, the return to removal.
Make sure that the vacuum hose is inserted so that connection of a vacuum hose concerns a ring of an inlet collector (LF).
Insert the socket of a vacuum hose in the amplifier of brakes.
Make sure that the vacuum hose is established reliably, having pulled for it, and again insert it in the amplifier of brakes.

Установка катушки усилителя тормозов
Fig. 6.14. Installation of the coil of the amplifier of brakes


Make sure that the coil of the amplifier of brakes is in the socket of a vacuum hose (fig. 6.14).

"previous page
6.2.4. Check of the backpressure valve of a vacuum hose (amplifier of brakes)
following page"
6.2.5.1. Check of a pedal of a brake