Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
6.1. General information
6.2. Brake system
6.2.1. Check and adjustment of elements of the brake system
6.2.2. Check of level of brake fluid in a tank of a hydraulic actuator of the working brake system
6.2.3. Removal of air from the brake system
6.2.4. Check of the backpressure valve of a vacuum hose (amplifier of brakes)
6.2.5. Removal and installation of a vacuum hose (amplifier of brakes)
6.2.6. Removal and installation of a pedal of a brake
6.2.7. Removal and installation of the main brake cylinder
6.2.8. Check of the sensor of level of liquid
6.2.9. Removal and installation of the vacuum amplifier of brakes
6.2.10. Check of the vacuum amplifier of brakes
6.2.11. Dismantling and assembly of the main cylinder
6.2.12. Removal and installation of a forward brake disk
6.2.13. Replacement of front brake shoes
6.2.13.1. Visual check of thickness of blocks
6.2.13.2. Removal of brake shoes
6.2.14. Removal and installation of the back disk brake mechanism
6.2.15. Check of the parking brake system
6.2.16. Removal, check and installation of the back sensor of speed of a wheel of ABS
6.2.17. Removal and installation of the hydraulic block of anti-blocking system of brakes
6.3. Tables
7. Onboard electric equipment
8. Body
 








6-2-13-zamena-perednikh-tormoznykh-kolodok.html

6.2.13. Replacement of front brake shoes




When the case of the cylinder is open, do not press a brake pedal, otherwise the piston will jump out. Do not damage a boot of the piston and do not allow hit of oil on a brake disk. Always replace blocks together with laying. If on laying there are traces of a rust or flaking of a rubber covering, replace them new. Turn off a connecting bolt only when dismantling and replacing a support assembled. In these cases suspend the cylinder case on a wire so that not to stretch a brake hose. You see off to extra earnings of frictional surfaces of brakes in case of boring or replacement of drums or disks, after replacement of brake shoes or frictional slips, and also if after the small run the pedal begins "to fail".

Передние тормозные колодки
Fig. 6.42. Front brake shoes: 1 – brake shoes; 2 – coupling springs; 3 – tightening plates




"previous page
6.2.12.1. Check of a brake disk and components of the brake mechanism
following page"
6.2.13.1. Visual check of thickness of blocks