Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
3.1. Coupling
3.2. Mechanical transmission
3.2.1. General information
3.2.2. Check and replacement of oil in the mechanical transmission
3.2.3. Removal and installation of the sensor of a speedometer of the car (without anti-blocking system of brakes)
3.2.4. Replacement of an epiploon (differential)
3.2.5. Removal and installation of the mechanism of gear shifting
3.2.5.1. Instructions on installation of a cable of the choice of transfer
3.2.6. Coupling case, dismantling of elements of a case of the main transfer
3.2.7. Check and assembly of components of differential and case of the main transfer
3.3. Automatic transmission
3.4. Driving mechanism
3.5. Tables
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 








3-2-5-snyatie-i-ustanovka-mekhanizma-pereklyucheniya-peredach.html

3.2.5. Removal and installation of the mechanism of gear shifting




Remove the rechargeable battery, its tray and an arm of fastening of a tray.

Механизм переключения передач автомобиля Mazda 3
Fig. 3.29. Mechanism of gear shifting of the Mazda 3 car: 1 – gear shifting lever; 2 – cover panel; 3 – clip; 4 – washer; 5 – sealing plate; 6 – main cable of the drive of switching; 7 – main cable of the choice of transfer; 8 – gear shifting lever block


Remove an element of the air filter.

Снятие панели приборов
Fig. 3.30. Removal of the dashboard


Having turned off seven bolts, two screws of fastening and having taken out three percussion caps, remove the dashboard (fig. 3.30).

Снятие модуля управления системы улучшения устойчивости
Fig. 3.31. Removal of the module of management of system of improvement of stability: 1 – bolts; 2 – sockets of power supply and management; 3 – module


Turn off three bolts of fastening and remove the module of management of system of improvement of stability (fig. 3.31).

Снятие блока управления климатической установкой
Fig. 3.32. Removal of the control unit of climatic installation: 1 – conditioner; 2 – control unit; 3 – sockets of power supply and management


Remove the control unit of climatic installation (fig. 3.32).

Снятие нижних воздуховодов
Fig. 3.33. Removal of the lower air ducts: 1 – right air duct; 2 – left air duct


Remove the lower air ducts (fig. 3.33).
Remove the lever and a cover of the lever of gear shifting.
Remove gear shifting drive cables.
Remove the gear shifting lever block.
You make installation as it should be, the return to removal.
Establish an element of the air filter.
After installation, be convinced that the lever of gear shifting can smoothly move to any situation.

"previous page
3.2.4. Replacement of an epiploon (differential)
following page"
3.2.5.1. Instructions on installation of a cable of the choice of transfer