Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
2.6. The Z6 engine – a mechanical part
2.6.1. Check of a belt of the drive of auxiliary units
2.6.2. Check of thermal gaps in the mechanism of the drive of valves
2.6.2.1. Adjustment of thermal gaps in the mechanism of the drive of valves
2.6.3. Check of a compression
2.6.4. Removal and installation of a chain of the drive of the mechanism of gas distribution
2.6.5. Replacement of laying of the block of cylinders
2.6.6. Replacement of a forward epiploon of a bent shaft
2.6.7. Replacement of a back epiploon of a bent shaft
2.6.8. Removal and installation of the engine
2.7. Lubrication system
2.8. Cooling system
2.9. System of an admission
2.10. Fuel system
2.11. System of production of the fulfilled gases and system of decrease in toxicity
2.12. System of ignition
2.13. Control system
2.14. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 








2-6-2-proverka-teplovykh-zazorov-v-mekhanizme-privoda-klapanov.html

2.6.2. Check of thermal gaps in the mechanism of the drive of valves




Uncover the rechargeable battery.
Disconnect a negative wire from the rechargeable battery.
Remove the lower cover and a mudguard (right).
Remove knot of the air filter.
Remove ignition coils.
Disconnect a ventilation hose.
Uncover a head of the block of cylinders.
Measure a valvate gap.
Turn a bent shaft clockwise so that the piston No. 1 was in compression step VMT.

Порядок измерения клапанных зазоров
Fig. 2.236. Order of measurement of valvate gaps


Measure a valvate gap in a point And (fig. 2.236).
If the gap does not meet standard, replace a pusher of the valve and adjust a valvate gap on average value.
Standard valvate gap (on the cold engine): 0,27–0,33 mm.

NOTE
Write down the measured values to choose the corresponding pushers of the valve for replacement.

Turn a bent shaft on 360 ° clockwise so that the piston No. 4 was in compression step VMT.
Measure a valvate gap in B point (see fig. 2.236).
If does not meet standard, replace a pusher of the valve and adjust a valvate gap on average value.
Standard valvate gap (on the cold engine): 0,27–0,33 mm.
Establish a cover of a head of the block of cylinders.
Connect a ventilation hose.
Install ignition coils.
Establish knot of the air filter.
Establish the lower cover and a mudguard (right).

"previous page
2.6.1.3. Check of an automatic natyazhitel of a driving belt
following page"
2.6.2.1. Adjustment of thermal gaps in the mechanism of the drive of valves