Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
2.6. The Z6 engine – a mechanical part
2.7. Lubrication system
2.8. Cooling system
2.9. System of an admission
2.10. Fuel system
2.11. System of production of the fulfilled gases and system of decrease in toxicity
2.12. System of ignition
2.13. Control system
2.13.1. Removal and installation of the sensor of temperature of cooling liquid of the engine
2.13.2. Removal and installation of the sensor of provision of a bent shaft
2.13.3. Removal and installation of the sensor of provision of a butterfly valve
2.14. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 








2-13-2-snyatie-i-ustanovka-datchika-polozheniya-kolenchatogo-vala.html

2.13.2. Removal and installation of the sensor of provision of a bent shaft

ATTENTION
When replacing the sensor of position of the crankshaft, make sure that on it there are no foreign objects, type of metal sawdust.
In the presence of sawdust or shaving the output signal of the sensor will be distorted owing to fluctuations of a magnetic flux that will lead to deterioration in work of a control system of the engine.

Uncover the rechargeable battery.
Disconnect a negative wire from the rechargeable battery.
Perform the following procedure for ensuring convenience of access.
Remove the lower cover.

Снятие датчика положения коленвала
Fig. 2.342. Removal of the sensor of position of the crankshaft


Remove the sensor of position of the crankshaft (fig. 2.342).
Establish as it should be, the return to removal.
Moment of an inhaling of the sensor of position of the crankshaft: 7,8–10,8 N · m.

"previous page
2.13.1. Removal and installation of the sensor of temperature of cooling liquid of the engine
following page"
2.13.3. Removal and installation of the sensor of provision of a butterfly valve