Mazda 3 since 2003
1. Operation and maintenance of the car
1.1. Description of the car
1.2. System of passive safety
1.3. Use of the car to destination
1.4. Elimination of the malfunctions which arose in way or before a start of motion
1.5. Tables
1.5.1. Table 1.1 car Dimensions
1.5.2. Table 1.2 Technical characteristics of engines (all models)
1.5.3. Table 1.3 Filling capacities of units and systems, the recommended operational materials
1.5.4. Table 1.4 of the Requirement to oils and working liquids
1.5.5. Table 1.5 of the Characteristic of pistons
1.5.6. Table 1.6 Technical characteristic
1.5.7. Table 1.7 of Operation on maintenance
1.5.8. Table 1.8
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 








1-5-7-tablica-1-7-operacii-po-tekhnicheskomu-obsluzhivaniyu.html

1.5.7. Table 1.7 of Operation on maintenance

Таблица 1.7 Операции по техническому обслуживанию

DESIGNATIONS IN THE TABLE:
П – To check: To check, clear, repair, adjust or to replace if necessary.
3 – To replace
About – to Clear
With – to Merge a water sediment
T – to Tighten

* Indications of the odometer or months, depending on what will come earlier.

THE NOTE TO TABLE 1.7:
* 1 Besides, check a state and a tension of belts of the drive of the pump of the hydraulic booster and compressor of the conditioner (in the presence on the car).
* 2 Check type of spark plugs on marking on candles. See technical characteristics of spark plugs.
* 3 If the car is operated in the conditions of strong dust content of air, then it is necessary to clear periodically and if necessary to replace the air filter more often, than it is specified in the table. Consult at the service station of the official dealer of Mazda.
* 4 Belt of the gas-distributing mechanism are subject to replacement through each 240000 km of a run of the car or 10 years. Failure to follow the specified requirement can lead to an engine exit out of operation.
* 5 If one of the listed below conditions is characteristic of operation of the car at least, then it is necessary to replace engine oil and an oil filter through each 10000 km of a run or is more often. Consult at the service station of the official dealer of Mazda.
– High dust content of air.
– Long operation of the engine idling or the long movement of the car at a small speed.
– Long operation at a low temperature of air or regular trips only on short distances (when the engine does not manage to get warm up to the normal working temperature).
* 6 If on a cover of a radiator or about it there is a marking of "FL22", then it is necessary to use cooling liquid of the FL22 brand. When replacing cooling liquid in the cooling system of the engine use FL22 brand liquid.
* 7 If brake mechanisms of the car are operated with big loading (for example, at a dynamic manner of driving, at operation of the car in the mountain area) or at very high humidity of air, then brake fluid should be replaced annually.


"previous page
1.5.6. Table 1.6 Technical characteristic
following page"
1.5.8. Table 1.8