Mazda 3 since 2003
1. Operation and maintenance of the car
1.1. Description of the car
1.1.1. Dimensions and general view of the car
1.1.2. Technical characteristics
1.1.3. Identification data of the car
1.1.4. Podkapotny space
1.1.5. Filling capacities of units and systems. The recommended operational materials
1.1.6. Keys, locks of doors, hatch, anticreeping system
1.1.7. Governing bodies and combination of devices
1.1.8. Information display
1.1.8.1. Indication of indications of time
1.1.8.2. Index of temperature of air
1.1.9. Electronic immobilizer (anticreeping system)
1.1.10. Heater, conditioner and system of ventilation of interior of the car
1.1.11. Lever of the drive of the parking brake system
1.1.12. Seats
1.2. System of passive safety
1.3. Use of the car to destination
1.4. Elimination of the malfunctions which arose in way or before a start of motion
1.5. Tables
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 








1-1-8-1-indikaciya-pokazanijj-vremeni.html

1.1.8.1. Indication of indications of time

Fig. 1.95. Mode of indication of the current time


The display shows the current time if the switch of ignition is in the provision of "ON" (ignition is included) or "ASS" (auxiliary consumers of the electric power). If data of the route computer are output to the display, press the CLOCK button (hours) to switch the display to the mode of indication of the current time (fig. 1.95).

NOTE
On the cars equipped with the route computer at installation of indications of hours it is necessary to use the INFO button (information) instead of the SET button (installation).

Installation of indications of hours.
and. Press and hold the CLOCK button (hours), the short sound signal will not be distributed yet. On the display the 12Hr or 24Hr indicator, the indications of time corresponding to 12 and 24-hour mode will light up.
. Press the SET button to switch 12 and 24-hour modes of indication of time. At the same time the indicator of the chosen mode will begin to blink.
To choose the required mode of indication of time, press the CLOCK button (hours) once again while the indicator of the chosen mode continues to blink.
century. Then on the display the indicator "Hr will light up. ADJUST" (installation of the current time – hours), and two left categories (hours) will begin to blink. By means of the SET button establish the required indications of the current time in two left categories (hours) and then press the CLOCK button (hours).
. Then on the display the indicator "Min will light up. ADJUST" (installation of the current time – minute), and two right categories (minute) will begin to blink. By means of the SET button establish the required indications of the current time in two left categories (hours) and then press the CLOCK button (hours).

Change of indications of hours.
During indication of the current time press the SET button and hold it not less than one and a half seconds. At an otpuskaniye of the button the short sound signal will be distributed, and indications of hours will change as follows, for example:
12:01–12:29–12:00
12:30–12:59–1:00

NOTE
At an otpuskaniye of the SET button there is a zeroing of categories of seconds.

"previous page
1.1.8. Information display
following page"
1.1.8.2. Index of temperature of air